..:: Welcome on IQ Home Website! Home of Industrial an Smart City IoT devices! ::..

1. Open your .PCB design files in Altium designer software. Select "File -> Fabrication Outputs -> Gerber software".

2. On tabs go to "General". Set the "Units" and the "Format" according to the picture.

3. On the "Layers" tab select everything you want to export in the "Plot" column and deselect everything you want to exclude in the "Mirror" column. (You can do this with one button in the dropdown menus on the bottom of the window.)

Uncheck everything in "Mechanical Layers".

4. Copy the settings from the "Drill Drawing" tab.

5. On the "Apertures" tab check "Embedded apertures (RS274X)".

6. On the "Advanced" tab configure everything according to the picture then press "OK".

7. The files will be automatically loaded into the Altium CAM viewer. This allows you to check whether all the layers have been generated correctly.

Go to "File -> Export -> Gerber" to export the Gerber files.

8. Fill in the next window according to the picture, then press "OK".

Generating NC Drill File

1. Go to "File -> Fabrication Outputs -> NC Drill Files"

2. In the "NC Drill Setup" setup window everything according to the picture then press "OK".

3. The generated files will be loaded in the Altium CAM viewer automatically. This allows you to check if all the settings are good.

Go to "File -> Export -> Gerber" to export the drill file. Check everything in the pop-up window according to the picture and press "OK".

Check the extensions of every generated file according to the table below. Rename them if necessary. After that, put them in a ZIP and then upload it to the Nyákfutár's order site.

A Gerber állományok kiterjesztésének átírása

Kiterjsztések 2 réteg esetén:

Top Layerpcbname.GTL
Bottom Layerpcbname.GBL
Soldermask Toppcbname.GTS
Soldermask Bottompcbname.GBS
Silk Toppcbname.GTO
Silk Bottompcbname.GBO
NC Drillpcbname.TXT / XLN
Mechanical Layerpcbname.GKO / GML

Egy réteg esetén csak a "Top" és "Bottom" fájlok szükségesek.

További Gerber fájlok 4 réteg esetén:

Inner1 layerpcbname.G2L / G1
Inner2 layerpcbname.G3L / G2

A rétegek növekedésével a belső rétegek száma is növekedik.

Gerber Export form Sprint Layout 6.0
Generate Gerber file from Sprint Layout...
Gerber export from CircuitMaker
Generate Gerber from CircuitMaker...
You might also like